Yale SmartHome Alarm series Especificações descarregar pdf (Página 16)

•Warningonisthefactorydefault.

Time

The control unit uses a 24 hour clock. The time

is set by using the pq keys and conﬁrmed by

pressing the 3 key.

Date

The day and month are set by using the pq keys

and conﬁrmed by pressing the 3 key.

Supervision

Enable or disable supervision detection on the

control panel. PIR, Door Contact, Smoke Detector

and Siren can be monitored for outage using

this feature. Except for Smoke Detector (which is

always on), the other three accessories need to

have supervision enabled on board to facilitate this

feature.

•DefaultsettingisDisable(recommended).

Tel. Settings

This menu allows you to program up to 3 telephone

numbers, record an address message and place

test calls, The following items can be selected.

•Tel.Numbers

•Rec.Address

•TestReport

Tel. Numbers

This menu has a list of 3 telephone numbers. These

numbers are dialed in order, a maximum of 20 digits

per number can be stored. Only one number is

required to enable the control unit to report over the

telephone line.

1 Use the pq keys to select a number from the list.

2 Press 3 to conﬁrm. If there was a number already

stored then you will be asked to change the

number, if the slot was empty you will be asked to

enter a new number, conﬁrm by pressing 3.

3 Enter your phone number and conﬁrm by

pressing 3. Press “Up arrow” key for

key (insert

3 seconds time gap, useful for switchboard) and

“Down arrow” key for the # key.

•ErrorscanbecorrectedbypressingP to

backspace, pressing P repeatedly will take

you back the telephone number list. Telephone

numbers can be deleted in the same manner.

Rec. Address

This menu allows the recording of your address.

The maximum length of message is 10 seconds

which is ample for most messages, when recording

remember to speak clearly and slowly into the

microphone.

1 Press 3 and you will be either asked to record a

new message or change an old one.

2 Press 3 again and follow the on screen

instructions. When you ﬁnish recording remember

to press 3 to stop recording. If you go over the

10 second recording time (indicated by a beep)

just repeat the recording procedure again taking

care not to go over the 10 second time limit. The

recording is complete.

Test report

This menu allows you to test the telephone reporting

feature.

•Pleasecheckwiththecallrecipientsbeforemaking

a test call.

•Ensurethatthephonecordisconnected.

1 Select Test report and press 3.

2 A list of numbers will be displayed, select the

number you want to test and press 3.

3 The control unit will now display call progress.

•Theaddressmessageandpre-recorded

emergency, burglar and acknowledgement request

messages will be played in a loop for 85 seconds.

•Thetestcanbecancelledatanytimebyeither

pressing the P button or the call recipient pressing

“9” on their phone to acknowledge the call. If a

radio DECT or mobile phone is used, remember to

press 9 repeatedly until the call closes.

•Checkthatthecallhasbeensuccessfullyreceived.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 31 32

Comentários a estes Manuais

Sem comentários

Yale SmartHome Alarm series Especificações Página 16

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Yale SmartHome Alarm series