Yale SmartHome Alarm series Especificações descarregar pdf (Página 19)

19

Disabling the system tamper

Before mounting it is important to disable the

siren and system tamper to avoid the siren

sounding an alarm.

1 Press the Menu key and enter a user PIN code

followed by 3.

2 The control unit is now in programming mode,

Select Devices, then Program Siren and Siren

Tamp. Off using the pq3 keys.

3 Press 3 when in the Siren Tamp. Off menu

and the control unit will beep followed by an

acknowledgement pip from the siren.

• Siren programming is described more fully

in “Control Panel Menu System in Detail” in

section 5.

• The siren tamper will now be disabled for 1

hour after which it will automatically arm again.

If longer is needed to ﬁt the siren then simply

repeat the steps above.

• Leave the control unit in programming

mode to stop the system responding to

tampers. If the control unit automatically

times out, re-enter programming mode

again.

i

Enabling the system tamper

After mounting the siren and detectors,

please enable the system tamper by:

1 Press the menu key and enter a user PIN

code followed by 3.

2 The control unit is now in programming

mode, Select Devices, then Program Siren

and Siren Tamp. On using the pq3 keys.

3 Press 3 when in the Siren Tamp. On menu

and the control unit will beep followed by

an acknowledgement pip from the siren.

4 Quit programming mode and system

tamper protection will be automatically

restored.

i

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 31 32

Comentários a estes Manuais

Sem comentários