Yale SmartHome Alarm series Especificações descarregar pdf (Página 20)

Adding and using Accessories

Preparation

See section 2 for battery insertion, activation and

part identiﬁcation. See also section 1 and section 4

for installation details and suggestions.

Adding accessories to your

system

1 From the programming menu of the control unit,

select the ‘Devices’ and press 3, select ‘Add

Device’ and press 3 again.

2 Press the Learn button on the device when

prompted and conﬁrm it is the correct detector by

pressing 3.

Learn buttons (see Chapter 2 for location):

• Keyfob: Press arm

• PIR: Press the test button

• Door/Window contact: Press the test button

• Help button: Press the emergency button

• Smoke detector: Press the test button

• Keypad: Press 8+9 together. The keypad needs

initialising rst, see keypad section on the right.

3 Depending on the device learnt in, ﬁnish the

programming as prompted.

Using your keyfob

•ThekeyfobcanbeusedtoAwayArm,Home

Arm, and Disarm the system using the buttons as

shown.

•Anemergencyalarmcanbeactivatedbypressing

the emergency button for 3 seconds until LED

stops ﬂashing.

•Anemergencyalarmcanonlybestoppedbyusing

the control unit keypad or a remote keypad.

•Thesystemcanonlybedisarmedafteranentryor

away entry sensor is activated (in the entry period).

Keypad

Keypad initialisation

If you purchase a keypad as an accessory, you will

need to initialise it prior to use with the control panel.

1 Press the ‘Panic button A’ key followed by factory

default keypad code ‘0000’ (this is different to your

control panel pincode).

2 The LED will now ﬂash slowly indicating it is in test

(programming) mode.

3 Press the ‘Panic button A’ key followed by the ‘7’

key to set the keypad into Control panel system

mode (also known as slave mode).

4 Quit test mode by pressing the disarm key twice.

The keypad code and mode setting has been

completed. The Keypad will now use the same

pincode that is set for the control panel unit.

Forgotten keypad code (different to control

panel pincode)

If the keypad code is accidentally forgotten, the

keypad can be reset to factory default (0000) using

the following steps:

1 Unscrew the two keypad case screws and remove

keypad back cover (please disable tamper ﬁrst).

Locate and remove the battery.

2 Press the number ‘4’ key at the same time as

reinserting the battery.

3 Screw the keypad case together and re-learn the

keypad into the system using the steps described

above in this section.

To provide additional protection you can add extra door/window contacts, PIRs, keyfob

remote controls, keypad remote controls, help buttons and smoke detectors. These are

available separately from your local stockist.

ale

Panic button A

Panic button B

Disarm

Home

Arm

LED

Learn button=

Press 8 and 9 together

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 31 32

Comentários a estes Manuais

Sem comentários

Yale SmartHome Alarm series Especificações Página 20

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Yale SmartHome Alarm series